Kingston 4GB, DDR4, 2666MHz (PC4-21300), CL19, DIMM Memory
KVR26N19S6/4
This document describes ValueRAM's KVR26N19S6/4 is a 512M x 64-bit (4GB) DDR4-2666 CL19 SDRAM (Synchronous DRAM) 1Rx16 memory module based on four 512M x 16-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR4-2666 timing of 19-19-19 at 1.2V. Each 288-pin DIMM uses gold contact fingers.
• Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP = 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for data strobe and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 8 internal banks; 2 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• PCB: Height 1.23” (31.25mm)
• RoHS Compliant and Halogen-Free
- Series: Kingston ValueRAM
- DDR Type: DDR4
- Size: 1 x 4GB
- Individual Module Size: 4GB
- Total Capacity: 4GB Total
- Speed: 2666 MHz
- Compliance: PC4-21300
- Pins: 288-pin
- CAS Latency: CL19
- Data Integrity Check: Non-ECC
- Voltage: 1.2V
- Timings: 19-19-19
- Heatspreader : No
- LED Lighting: No
- Additional Information: See Overview
- Package Type: Retail
- Package Weight: 0.0225 kg
- Warranty: Lifetime
KVR26N19S6/4
15 Items
Data sheet
- Frequency
- 2666MHz
- Configuration
- 1 x 4GB Kit
Comments (0)