- Out-of-Stock
Kingston 4GB, DDR3, 1600MHz (PC3-12800), CL11, DIMM Memory, Single Rank
KVR16N11S8/4
KVR16N11S8/4
4GB 1Rx8 512M x 64-Bit PC3-12800 CL11 240-Pin DIMM
ValueRAM's 512M x 64-bit (4GB) DDR3-1600 CL11 SDRAM (Synchronous DRAM) 1Rx8 memory module based on eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1600 timing of 11-11-11 at 1.5V. This 240-pin DIMM uses gold
contact fingers.
Features
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11 10 9 8 7 6
• Programmable Additive Latency: 0 CL - 2 or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit sequential with starting address “000” only) 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 0.740” (18.75mm) single sided component
- Series: Kingston ValueRAM
- DDR Type: DDR3
- Size: 1 x 4GB
- Individual Module Size: 4GB
- Total Capacity: 4GB Total
- Speed: 1600 MHz
- Compliance: PC3-12800
- Pins: 240-pin
- CAS Latency: CL11
- Data Integrity Check: Non-ECC
- Voltage: 1.5V
- Heatspreader : No
- LED Lighting: No
- Package Type: Blister Pack
- Package Weight: 0.0225 kg
- Warranty: Lifetime
KVR16N11S8/4
Data sheet
- Frequency
- 1600MHz
- Configuration
- 1 x 4GB Kit
Comments (0)